Up to 2000 contact names with four numbers per contact will transfer to the system's phonebook.Check “Do not ask again," then accept the “phonebook download” request on your phone.Your phone can still be connected manually. Many phones don't automatically reconnect after being restarted.Refer to your phone manufacturer or cellular provider for instructions. Set your phone to "auto-connect" or "trusted device" within the phone's Bluetooth® settings.Your phone won't reconnect to the system after pairing Verify you are selecting “Uconnect” in the discovered Bluetooth devices on your phone.Delete the pairing history in your phone and Uconnect® system, which is usually found in the phone's Bluetooth® settings.Perform a hard reset in the phone by removing the battery (if removable – see your phone's owner's manual).If the issue is still unresolved, service may be required. If your car stereo does have this setting, make sure to turn this setting off. Check to see if your unit has a dimmer setting, which can disable the display.NOTE: Pressing the RESET button will erase the clock setting and some of the stored contents. Press the RESET button with a pointed object, such as a ball-point pen.NOTE: On some models, this will toggle the display on and off. Press and hold the OFF button for a few seconds.NOTE: Information regarding cleaning the connectors is available in the manual that came with your product. Wait approximately 2 minutes before reattaching the front panel.Using a cotton swab lightly dipped, not soaked, in alcohol, clean the connectors on the front of the main unit and on the back of the front panel.Detach the front panel from the car stereo receiver.Never touch the connectors directly with your fingers or any metal device.Otherwise, the connectors may be damaged. Do not apply too much force when cleaning the connectors.For safety, before cleaning the connectors, turn off the engine and remove the key from the ignition switch. WARNING: There is a risk of personal injury. In order to prevent this, do the following: The car stereo may not function properly if the connectors between the unit and the front panel are not clean.Manuals are posted on your model support page. IMPORTANT: Consult the operating instructions of the car stereo for model-specific information. Follow these steps to troubleshoot this issue: Intermittent flashing may occur if the connectors need to be cleaned or if something affected the memory of the car stereo system, such as a power fluctuation.
0 kommentar(er)
